HZ-7150 Oxypropane High Heat Welding Torch

Question:

Can you change the torch head?

Answer:

I haven't tried yet but it's possible.
By Paul Miller on August 2, 2022

Question:

Do u need regulators ?

Answer:

No.
By Jay Sauder on November 4, 2019

Question:

Can it cut cast iron?

Answer:

All depends in the thickness and the length of the item your cutting. In most cases the problem is not the torch, is the cyclinders. The map gas last but the oxygen run out to fast. It should be equal, but in my personal experience, I was not that lucky. Example:
I needed to cut a fence post (2" diameter), my saw battery was to low, I then pull out the torch I was able to cut the post but it used two oxygen cylinder and one map gas to cut a 2" pipe. Cast Iron, it will cut it, but make sure you have some extra oxygen cylinder. By the way, make sure its not windy, or else you need to ignite many times, which in the end you will regret purchasing this item. In other word, it very handy for small project.
By Arvegon on October 31, 2020

This thing is absolute garbage, it won’t even work with aluminum
By Mark E Anderson on October 31, 2020

Question:

Are replacement tips available? I would rather buy a new tip than another whole setup.

Answer:

No
By Mar on April 25, 2020

Question:

Can you really cut hard steel with that

Answer:

No I just use it for some brazing/soldiering
By Mike on January 15, 2020

I don't know because it never work something was wrong with one of the pieces of the connection to the tank and it was already used when I got it
By Victor Inzunza on January 18, 2020

Question:

Are replacement tips available?

Answer:

No
By Mar on April 25, 2020

Question:

Do u need regulators ?

Answer:

No
By Mar on November 27, 2019

Question:

What is the weight of this item?

Answer:

Couple pounds
By shopper #11 on February 25, 2020

Question:

How could i purchase just the hose and regulator setup? I live in hawaii, hazmat restrictions.

Answer:

There is no regulators
By Mar on November 27, 2019

Question:

Why is the oxygen left hand threaded on the valve? It seems that the consumer standard is right hand threads on the depicted tanks.

Answer:

Industry standard. Comes from big tank rigs. Can't mix regulators mixed up.
By shopper #11 on February 25, 2020

This i a industry standard safety requirement so as to not to be able to be confused about the regulators placement
By patrick on February 23, 2020

Question:

Why is their no reviews?

Answer:

Hi, Thanks for asking. This item was listed not long enough.
By BLUEFIRE on November 26, 2019

Probably bc this item SUCKS. getting the oxy/MAPP ratio right is next to impossible. J can’t even do it.
By Mar on October 2, 2019

Question:

You say use "medical Oxygen Bottle"/other oxygen bottles with this, does the coupler fit other bottles, how long typically does a regular oxygen last?

Answer:

They fit the bottles that are the same size and threading as the mapp. And it doesn’t last very long. Maybe half the time of the mapp. MAYBE
By Mar on April 25, 2020

HZ-7150 Oxypropane High Heat Welding Torch